GRAUPNER Junior Série Manuel D'utilisation page 31

7. Charge
1. Connect the charger wire
to the USB port of your
computer. The LED in the
USB connector starts to lit.
8. Install Gcontrol Module
9. Fly the helicopter with the Gcontrol Interface
1. Climb
Push the throttle stick up to
increase the motor speed - the
helicopter rises
Operating Instructions Nano Star 3 Gcontrol
2. Connect the charger wire
with the round plug to the
Gcontrol module. The red
LED lights up.
When the battery is fully
charged, the LED turns
off. Unplug the charger
from Gcontrol module.
Warning:
when the blue LED of the
Gcontrol module starts blin-
king, charge immediately!
Connect the Gcontrol-Module with the earphone jack of your Apple
device. After switching on the Gcontrol module over the interface the
blue LED on the module starts to lit.
Dial the phone volume to maximum.
2. Sink
Pull the throttle stick up to
decrease the motor speed - the
helicopter sinks
3. Turn OFF the helicopter. Connect the
charging wire with the angled plug
with the charging jack on the left side
of the helicopter.
tor system is polarised, do not
use force. The LED in the USB
plug goes out. If the battery is fully
charged, the LED lights up again. Un-
plug the charging cable from the heli-
copter.
3. Yaw left
Press the direction stick to the
left - the nose of the helicopter
turns to the left
The connec-
-
®
30