GRAUPNER Junior Série Manuel D'utilisation page 24

Special notes
1. If you fi nd that the model's nose constantly turns in one direction, turn the trim knob in the
opposite direction until the rotation ceases.
2. To save battery power, the transmitter switches off automatically after a few minutes from
itself when not in use (Power LED off).
3. The helicopter can be operated on three different channels (A-B-C). Select the channel,
switch the transmitter on, then switch the helicopter on; if the LED on the circuit board in the
fuselage lights up, you can start fl ying
5. Flying the model
Pre-fl ight checking
If there are several helicopters at the fl ying site, check beforehand that your model is the only
one on "your" channel before you switch the transmitter on. Two transmitters on the same chan-
nel causes interference, and may result in other models crashing.
Before fl ying the model check that all parts are in place and fi rmly secured.
The helicopter must always be held in such a way that the rotors are free to spin, other-
wise they may cause injury when they start turning.
23
Operating Instructions Nano Star 3 Gyro