Laserworld Purelight PL-5000RGB Mode D'emploi page 4

Manual: Purelight Series
Content:
1. Product and package contents
2. Preliminary warning notices
3. Initial operations, safety instructions
4. Working on the device
5. Service notes
6. General Operation
7. Operation Modes
Final statement
Find information on how to operate your laser here:
https://www.laserworld.com/en/online-manual
page 6 / 23
1. Product and package contents
Please check if all listed parts are included and undamaged. Included in delivery:
Laser system, power cable, key, interlock bridge plug, manual, technical datasheet
7
7
2. Preliminary warning notices
7
8
1. Please use this device only according to these operating instructions.
8
2. Do not use the device if there are any visible damages on housing, connector panels,
power supplies or power cords.
9
3. This device must not be permanently connected to mains. Disconnect it from mains or
10
use the power button to switch if off if not in use.
4. Never look directly into the light source of a laser projector. Danger of damage to the
11
eyes or even blindness in extreme circumstances!
5. Do not operate the device at high humidity or in the rain or in dusty environments.
6. Protect device against dripping or splashing water. Do not place any liquid filled
containers near to this device.
Any warranty claims are void if the warranty label is removed or tampered
with in any way.
3. Initial operations, safety instructions
1. Make sure to use correct voltage; see in-
formation on device & in this manual.
2. Make sure that the device is not connec-
ted to mains during installation.
3. Installation has to be done by technical
experienced and qualified persons ac-
cording to safety regulations of the res-
pective country.
4. Always ensure that maximum permissi-
ble exposure (MPE) is not exceeded in
areas accessible to the public or members
of staff.
5. In some countries an additional
pection by technical control institutes
could be necessary.
6. Connect an easily accessible inter-
English English
Manual: Purelight Series
lock connector or circuit breaker
to the projector.
7. The power supply should be easily acces-
sible.
8. When installing the laser mount it with
a minimum distance of 15 cm from walls
and objects.
9. For safe setup e.g. on walls or ceilings
please use a safety cord. The safety cord
should be able to withstand tenfold the
weight of the device. Please follow the
accident prevention regulations of pro-
fessional associations and/or comparable
ins-
regulations for accident prevention.
10. If the device has been exposed to great
temperature changes, do not switch it
on immediately. Condensation (or any
moisture/water formed) may damage
page 7 / 23