Timer-Recording Radio Programs - Sony digipad MHC-DP1000D Mode D'emploi

Timer-recording radio
programs
To timer-record, you must set the clock (see
"Setting the time" on page 15) and preset the
radio stations (see "Presetting radio stations"
on page 40) beforehand.
1
Tune in the preset radio station (see
"Listening to the radio" on page 40).
2
Press CLOCK/TIMER SET.
"DAILY1 SET" appears.
3
Press . or > repeatedly to select
"REC SET", then press ENTER.
"ON" appears and the hour indication
flashes.
4
Set the time to start recording.
Press . or > repeatedly to set the
hour, then press ENTER.
The minute indication flashes.
Press . or > repeatedly to set the
minutes, then press ENTER.
The hour indication flashes again.
5
Set the time to stop recording following
step 4.
The start time appears, followed by the stop
time, the preset radio station to be recorded
(e.g., "TUNER FM 5"), then the original
display appears.
6
Insert a recordable tape into deck B.
7
Turn off the power.
When the recording starts, the volume level
is set to the minimum.
To Do this
Check the setting Press TIMER SELECT (or
CLOCK/TIMER SELECT on
the remote) and press . or
> repeatedly to select
"REC SELECT", then press
ENTER.
Change the setting Start over from step 1.
Cancel the Press TIMER SELECT (or
Timer-recording CLOCK/TIMER SELECT on
the remote) and press . or
> repeatedly to select
"TIMER OFF", then press
ENTER.
Notes
• If the power is on at the preset time, the Timer-
recording does not work.
• When you use the Sleep Timer, the Timer-recording
will not turn on the system until the Sleep Timer
turns it off.
• The power turns on 15 seconds before the preset
time.
GB
45