cascade corporation F Série Instructions D'installation page 5

I
NSTALLATION
Follow the steps shown to install the Roll Clamp on the
truck. Read and understand all WARNING statements.
If you don't understand a procedure, ask your supervisor,
or call the nearest Cascade Service Department for
assistance.
1
2
Unlock Quick-Change lower
mounting hooks (if equipped)
A
Move hooks into unlocked position
(pin in lower hole).
Guide
Pin
781578-R3 EN
Attach overhead hoist
A
Remove banding, set clamp
upright on pallet.
B
Remove bolt-on lower mounting
hooks (if equipped).
A
®
e
a d
s c
c a
- 1
1 4
5 5
6 7
C -
LH lower
QC Hook
WARNING: Check weight on nameplate
of Roll Clamp and make sure overhead
hoist is rated appropriately.
A
5/8 in. (16 mm)
offset on top
provides
maximum
clearance.
A
B
NOTE: Guides can be reversed to
change hook-to-carriage clearance
(See Step 7).
CL0097.eps
Tighten Capscrews:
CL II & III – 110 ft.-lbs. (150 Nm)
CL IV 60F, 66F, 77F – 195 ft.-lbs. (265 Nm)
CL IV 90F and larger – 260 ft.-lbs. (360 Nm)
RC0967.ill
3