cascade corporation F Série Instructions D'installation page 3

S
PECIAL DEFINITIONS
The statements shown below appear throughout this
Manual where special emphasis is required. Read all
WARNINGS and CAUTIONS before proceeding with
any work. Statements labeled IMPORTANT and NOTE
are special information that is useful when servicing the
attachment.
WARNING - A statement preceded by a
WARNING is information that should be
acted upon to prevent bodily injury. A
WARNING is always inside a ruled box.
CAUTION – A statement preceded by CAUTION is
information that should be acted upon to prevent
machine damage.
IMPORTANT – A statement preceded by IMPORTANT is
information that possesses special significance.
NOTE – A statement preceded by NOTE is information
that is handy to know and may make the job easier.
R
ECOMMENDED HYDRAULIC SUPPLY
F-Series Fixed Frame Paper Roll Clamps provide the best
performance with the hydraulic supply arrangements
shown below. Refer to Cascade Hose and Cable Reel
Selection Guide, Part No. 212119, to select the correct
hose reel for the mast and truck. The hose and fitting
requirements are:
• ROTATE Function – Hoses and fittings should be No. 8
with 13/32 in. (10 mm) minimum I.D.
• CLAMP Function – Hoses and fittings for the CLAMP
function should be:
25F – No. 6 with 9/32 in. (7 mm) minimum I.D.
38F-160F – No. 8 with 13/32 in. (10 mm) minimum I.D.
A and B
RH and LH THINLINE™ 2-Port Hose Reel Groups.
OR
A and C
RH THINLINE™ 2-Port Hose Reel Group and Mast
Single Internal Hose Reeving Group.
781578-R3 EN
A
B
C
GA0033.eps
1