cascade corporation F Série Instructions D'installation page 2

C
ONTENTS
Introduction
Special Definitions
Recommended Hydraulic Supply
Truck Requirements
Installation
Periodic Maintenance
I
NTRODUCTION
This Manual provides installation instructions and periodic
maintenance requirements for Cascade F-Series Paper
Roll Clamps.
In any communication about the Roll Clamp refer to the
product I.D. number stamped on the nameplate. If the
nameplate is missing, the numbers can be found stamped
on the front of the faceplate top or side.
IMPORTANT: All hoses, tubes and fittings on F-Series Roll
Clamps are JIC.
NOTE: Specifications are shown in both U.S. and (Metric)
units.
Nameplate Locations
i
i
1
1
2
3
8
Weighted Emission Sound Pressure Level - Weighted
emission sound pressure level (LA) does not exceed 70
dB(A).
Measured Value of Whole Body Vibration - Measured
value of whole body vibration (m/s 2 ) does not exceed 0,5
m/s 2 .
Measured Value of Hand-Arm Vibration - Measured value
of hand-arm vibration (m/s 2 ) does not exceed 2,5 m/s 2 .
c
LIFT TRUCK ATTACHMENT
674870
SERIAL
NUMBER
60F-RCP-459
CATALOG
NUMBER
ADDITIONAL
EQUIPMENT
ADDITIONAL
EQUIPMENT
ADDITIONAL
EQUIPMENT
RC0720.eps
ATTACHMENT CAPACITY
POUNDS
AT
CAPACITY OF TRUCK AND ATTACHMENT COMBINATION
MAY BE LESS THAN ATTACHMENT CAPACITY SHOWN
WEIGHT
ABOVE. CONSULT TRUCK NAMEPLATE.
LBS.
RECOMMENDED SYSTEM PRESSURE – 2000 PSI
MAXIMUM SYSTEM PRESSURE – 2300 PSI
FOR TECHNICAL ASSISTANCE, PARTS AND SERVICE
CONTACT:
1-800-227–2233
PORTLAND, OREGON USA
781578-R3 EN
INCH LOAD
CENTER