Sinmag Europe HS-3 Mode D'emploi page 6

ENG
4. COMMISSIONING
Before operating, please press the blade to check if its tension degree is appropriate. ,
Turn the knob to adjust the blade to a proper tension (See the picture 1).
1
Switch on the machine to see if the conveyor belt is slipping.
Adjust the screw to give the belt a proper tension (See picture 2).
If the conveyor belt derives to the left, adjust the screw on the left hand side.
If the conveyor belt derives to the right, adjust the screw on the right hand side.
2
5. OPERATION
HS-3
Adjust the width of the guide plate outside of the conveyor belt (normally 3
1
hamburgers width is ok), then change the height of the blades according to the
desired thickness.
Switch on the power supply.
2
Place the bread or cakes on the conveyor belt.
3
The belt will transport them to be sliced.
4
HS-3S
Adjust the width of the guide plate outside of the conveyorbelt (normally 3
1
hamburgs' width is ok), then change the height of the blades according to the
desired thickness.
Place the breads or cakes on the conveyorbelt.
2
Lower the upper conveyor belt against the product.
3
You can set the speed of the upper conveyor belt.
4
Switch on the powersupply.
5
The belts will transport the products to be sliced.
6
6
SINMAG EUROPE BVBA