Description Of The Registers; Function Registers - ADEUNIS sigfox RC1 Pulse Guide Utilisateur

sigfox RC1 Pulse - Guide utilisateur / User guide version V2.0.2
3.4.

Description of the registers

On switching on the product works according to the last saved configuration (Factory Configuration if it is the first start, or if this configuration
has not been changed).
Commands such as Modification TTY<n>=<M> or ATR allow you to change the content of the registers: <n> repre-senting the number of
the register and <m> the value to be assigned. This latter is either a decimal value or a hexadecimal value consistent with the «encoding»
column of the tables below.
Examples :
• ATS300=6 assigns the decimal value 6 in register 300
• ATS302=2 assigns the hexadecimal value 0x02 in register 302
It is imperative to save the parameters with the command AT&W before exiting the Command mode otherwise all changes will be lost.

3.4.1 Function registers

The list of registers below allows you to change the behavior of the product application.
Register Size Description
(bytes)
Transmission period of the
S300 N/A
Keep Alive frame
Transmission period of data
sensors
S301 1
PIN code
S304 1
Global operation
S306 2
Number of downlink frame
per day
S307 1
Coding Details
Ignored value, the period is set to 24 hours (not configurable)
---
in OPERATION mode and 5 minutes in TEST mode
Default: 144
Min/max: 1 to 144
Decimal
Unit:
x 10 min if S306=1
x 20s if S306=2
Default value : 0 (disabled)
Min/max : 0 to 9999
PIN code used with ATPIN command.
Decimal Value 0 disables the PIN code.
IMPORTANT: The product does not have a mechanism
to unlock the PIN code if it is activated and the code
is forgotten.
Default: 0
Allows the product to be switched into one of the following
modes:
Decimal • 0: PARK mode
• 1: Production mode
• 2: TEST mode
• 3: REPLI mode
Default: 0
Min/Max: 0 to 4
Decimal
Unit: none
See detail paragraph 4.2
EN
Page 77 of 104