ADEUNIS sigfox RC1 Pulse Guide Utilisateur page 76

sigfox RC1 Pulse - Guide utilisateur / User guide version V2.0.2
Table of AT commands:
Command
+++
ATPIN <PIN>
AT/V
AT/N
EN
ATS<n>?
AT/S
ATS<n>=<m>
AT&W
ATO
ATT63 PROVIDER
Example of a set of commands and corresponding responses that can be seen on the terminal:
Syntax
of the order
+++
ATS317=0
ATT63 PROVIDER
ATS317=0
ATS317?
AT&W
ATO
Interpreting the previous example: the user wanted to deactivate the respect of the Duty Cycle after having made an unauthorized command
(answer E), and the registers were unblocked in order to modify the register. The register S317 was verified and the parameters were saved
before exiting. When exiting command mode, the device will start a new cycle of emission.
Description
Input request in command mode
Gives access to AT commands if register S304 is
different of 0
Feeds back the version of the APPLICATIF and
RTU software
Feeds back the type of network
Feeds back the content of the n range
Edits the content of all of the user ranges in the
form of a list.
Transfers the m VALUE to the n range
Saves the current configuration to non-volatile
memory.
Exit command mode
Unblock the operating range
Description
Input request in command mode
Deactivation of the respect of the Duty Cycle E -> This command is not validated (register no un-
Unblock the operating range
Deactivation of the respect of the Duty Cycle O
Feeds back the value of the S202 range
Memory request for the state range
Output request in command mode
Reply example
CONNECTING... <cr><lf>
CM<cr><lf>
APP_8230EAA_PRG1706_V01.02.02:RTU_RTU_WM-
BUS_868_PRG_1601_V00.00.03
Or
APP_8181AAA_PRG1701_V01.00.02:RTU_8120AAB_
PRG_1701_V01.00.01
"LoRa" or "SIGFOX" or « WMBUS »
Sn=y where y represents the content of the n range
/
«O»<cr><lf> if Ok, «E»<cr><lf> if error, «W»<cr><lf> if
coherency error
«O»<cr><lf>, «E»<cr><lf> if coherency error
«O»<cr><lf>, «E»<cr><lf> if coherency error
«O»<cr><lf>
Response Syntax to Next Line
CONNECTING...
CM
locked)
O
S317=0
O
O
Page 76 of 104