Programming Instructions; Keypad Functions - Fracarro D-Matrix 4S EVO Instructions D'emploi

A PC can be used alternatively to configuration from the panel, by accessing the programming using a web interface (see the paragraph 5.2
PROGRAMMING BY WEB INTERFACE).
If required, the product can be reset to the factory.
ATTENTION: in this condition English is the default language.
After resetting the factory settings, the D-Matrix 4S EVO will have to be reprogrammed, as the preset parameters may not coincide with the
required ones.
D-MATRIX 4S EVO can be programmed using the keypad and display directly from the front panel. Press √ to access the programming menu and
input the user code (default code is 1234), then confirm the code by pressing √ again. Use the arrow up and down keys to move around the menu
and select the required parameter, press √ to confirm and enter the selected parameter. To exit the selection press X.
When viewing a parameter, use the arrow right and left keys to select the required value, then press X to exit (no confirmation is required). If
required, use the 0-9 keypad to input a numeric value, then press √ to confirm.
NB: The configuration interface timeout is 5 minutes: after that time, if no other changes are made to the program, the last saved configuration
by the product or the factory configuration is reinstated.
The menu is available in various languages. To change the menu language, access the main "LANGUAGE" menu, select the required language
and press √ to confirm.
• Arrow up / arrow down: To surf among the various menu items;
• Arrow left / arrow right: To select the parameter value;
• √: To confirm an input value or enter a submenu;
• X: To cancel an input value or to exit a menu or a submenu;
• S: To save the changes;
-
INPUT MENU: allows you to select the input to be programmed between 5 available (see flow chart INPUT)
Wrong PIN

5. PROGRAMMING INSTRUCTIONS

5.1 BASE PROGRAMMING FROM THE PANEL

KEYPAD FUNCTIONS

FLOW CHART INPUT
after 3 incorrect entries
28
for INPUT 1 the choice will be blocked on CONNECTOR