Setting Configuration - Fracarro D-Matrix 4S EVO Instructions D'emploi

• Auto SID Remapping: if enabled this innovative function allows automatically resetting a new progressive SID to the programs and to change
the list.
• Auto program name: if enabled this innovative function allows automatically resetting a new progressive name to the programs by writing it
in the space (base name), e.g. program 1, program 2, etc.
• Auto LCN: if enabled this function allows setting a base LCN number that is assigned to the first program in the list, the following ones will
then be set automatically in a sequence from the base number.
• LCN country: select the country for setting the LCN.
After, certain advanced signal parameters can be viewed: Original Network ID, Network ID, and the Private Data Specifying Descriptor.
Other parameters like Transport Stream ID, Network Name, Cell ID can be set and changed by writing the new number in the space.
NB: click on "Apply" to make the changes effective.
From the menu CONFIGURATIONSETTINGS the general system configuration page can be opened.
Fig. 13
From the MONITORING  CONFIGURATION menu, you can set all parameters
relevant to the headend monitoring. The menu is divided into three sections:
Monitoring settings, Date and Time Settings, Email Settings.
Enabling monitoring: for disabling or enabling the monitoring function,
Saving on a log file: for enabling or disabling the saving on a monitoring file
Duration of the log file: for enabling its duration.
The Empty key allows you to delete all monitored events from the log file.
Send an alarm email: for enabling or disabling the dispatch of an alarm email
in the event one or more parameters exceeds the operation range you have set.
Date: for setting the date of the headend, by entering it in the proper box.
Time: for setting the time of the headend by entering it in the proper box.
Tuning date and time (NTP): for enabling or disabling the tune of date and time of
the headend with those of the server.
NTP tuning server: for setting the address of the server that is used for tuning the
date and the time of the headend (default: 0.it.pool.ntp.org).
Country time: for setting the time of the installation country.
Smpt server: for setting the support server's address for performing the function
of sending the monitoring email by entering the address in the proper box.
Receiver email address: for setting the email address where the monitoring
message will be sent.
Sender email address: for setting the email address from which the monitoring
message will be sent (default: 3dg_glex@fracarro.com).
Furthermore, by clicking the key "send test email, " you can send a test email to make sure that the email works properly.
Click the "Save" key to apply the modifications.

5.2.6 SETTING CONFIGURATION

In this menu you can:
• Rename the system
• Change the access password
• Adjust the display contrast
• Display the installed software version
• Change the network connection settings.
5.3 MONITORING
Operating instructions
41
Fig. 14