Error Messages - Multiplex Power Peak B7 EQ-BID 12/230 V Notice D'utilisation

9.

ERROR MESSAGES

The Power Peak ® B7 EQ-BID is equipped with special safety features to ensure safe and
reliable charging and discharging operations. As soon as a fault occurs, a corresponding
message appears on the screen, and the piezo buzzer emits a shrill warning tone. After
eliminating the cause, you can erase the following error messages by pressing any button.
INPUT VOLTAGE LOW
CHARGE
NO BATTERY
CELL BATTERY TYPE
ERROR
BID-INCOMP
BID-EEPROM ERROR
OVERHEATING
Operating Instructions
Power Peak ® B7 EQ-BID
Input voltage below the permitted range
(10.5 Volt)
Charge or discharge process started with no
battery connected; connect battery.
Incorrect cell count or battery type
Incorrect data on the BID chip / key.
(cell count of LiPo battery may be greater than seven)
Incorrect data on the BID chip / key.
The BID chip / key must be re-edited.
The charger has overheated. Switch it off and allow
it to cool down.
19
47
# 30 8566