Using An External Subwoofer - Yamaha ATS-1050 Mode D'emploi

Clearing all programmed functions
1
With the sound bar turned off, hold down the LEARN key on the
sound bar's remote control for more than 3 seconds (for entering the
learning mode).
When the sound bar is in the learning mode, the indicators on the top panel flash as
shown below.
LEARN BLUETOOTH
STANDBY
2
Hold down (input) on the rear panel of the sound bar for more
than 3 seconds.
The corresponding indicator of the learned function turns off and the indicators on
the top panel flash as shown below.
If the clearing is completed, you will hear the bleep sound three times.
3
Press the LEARN key on the sound bar's remote control.
14

Using an external subwoofer

The sound bar has dual built-in subwoofers; however you can connect an external
subwoofer when you want to enhance low frequency sound. Connect a subwoofer to the
SUBWOOFER OUT jack of the sound bar. Sound is output from both the built-in
subwoofers and external subwoofer.
Pin cable for subwoofer
(commercially available)
NOTE
• Use an external subwoofer with built-in amplifier.
SUBWOOFER OUT
Mono input