Bticino Terraneo 332650 Notice De Montage page 78

When using the device, the time lapse between two
keystrokes must not exceed 5 seconds.
If the above instructions are not observed, or a non-
recognized code is entered, programming and use will be
interrupted.
The interruption is signaled by a sound, by the turning on
of the 5 red 1 LEDs for the same time, and the keypad will
be disabled for 15 s.
The previously stored codes, times and operating modes
will continue to be valid.
In case of a device error in the turning on phase, the LEDs
corresponding to the two outputs will alternatively flash.
When supply is re-established after a power failure, the
code-lock module will operate according to the operating
previous to the interruption.
The device is delivered from the factory with the following
default values:
MASTER = 1234
CODE A = 12345 monostable T = 1s
CODE B = 67890 monostable T = 1s
77