General Instructions - Bticino Terraneo 332650 Notice De Montage

i) Press key (indicates the end of the programming
*
sequence)
The programming sequence for code "B" in bistable mode
is thus as follows:
A B C D E F G H I
MMMM 2 BBBBB 00 K
** * *
N.B.
When programming codes "A" and "B" in bistable mode, it
is possible to omit value "K"; in this case , the following
default value will be adopted:
K = 1 (5-digit activation and LED turned on for the entire
activation time)

General instructions

When programming the device, the following instructions
must be observed:
a) The time lapse between two keystrokes, only when
entering the "MASTER" code, must not exceed 5 seconds.
b) The programming sequence must take place in a single
phase to be valid and within a time limit of 1 minute.
c) The first two digits of code "A" must be different from the
first two digits of code "B".
76