Programming Of Code "A" In Monostable Mode - Bticino Terraneo 332650 Notice De Montage

Programming of code "A" in monostable mode

(3, 4 or 5 digits)
a) Type in
* *
b) Type in the "MASTER" code
c) Press key
d) Press key 1 (indicates programming of access code for
output A)
e) Press the keys (only digits) of the desired code
f) Press key
g) Press the keys corresponding to the desired activation
time for output A (always 2 digits, from 01 to 99 for activation
time from 1 s to 99 s)
h) Press the key corresponding to the desired type of
activation:
-0- for 2-digit activation (LED turned on for a time
corresponding to TT value)
-1- for 3-, 4- or 5-digit activation (LED turned on for a time
corresponding to TT value)
i) Press key
sequence)
The programming sequence for code "A" in monostable
mode is thus as follows:
A B
MMMM
**
72
(indicates that a previous code will be changed)
(indicates programming of an access code)
*
(indicates the end of access code)
(indicates the end of the programming
*
C D
1 AAA(AA)
*
E F G H I
TT K
*