Bticino Terraneo 332650 Notice De Montage page 71

programming phase.
Furthermore, it is also be possible to enable both outputs
(both in monostable and bistable mode) by simply keying
in the first two digits of the respective access code, while,
for disabling them, the entire sequence of envisaged digits
must be typed in (only bistable).
The activation of outputs A and B in monostable mode will
be signaled by the lighting up of the corresponding 4 - 3
LED for a length of time identical to the one defined in the
programming phase (from 01 s to 99 s).
To activate outputs A and B in bistable mode it is instead
possible to choose whether to light up the corresponding
LED for a time span limited to 10 s or for the entire activation
time of the output.
For security reasons, a "MASTER" code directly
programmed by the customer is contemplated, by means
of which it is then possible to program the activation time
and the codes of the outputs to be enabled.
Furthermore, it is possible, if the user realizes he has
entered a wrong digit, to erase it by pressing key C.
If key C is pressed only once, the previously entered digits
and the corresponding 1 LEDs will be held valid, and only
the last entered digit and the corresponding visible signal
will be cleared.
If key C is pressed more than once, the number of digits
and 1 LEDs that are cleared is equal to the number of times
key C has been pressed, all the way to the complete clearing
of the typed in code.
70