Programming Of Code "A" In Bistable Mode - Bticino Terraneo 332650 Notice De Montage

N.B.
When programming codes "A" and "B" in monostable mode,
it is possible to omit values "TT" and "K"; in this case, the
following default values will be adopted:
TT = 01 (activation time 1 s)
K = 1 (3-, 4- or 5-digit activation)

Programming of code "A" in bistable mode

(always 5 digits)
a) Type in
* *
b) Type in the "MASTER" code
c) Press key
d) Press key 1 (indicates programming of access code for
output A)
e) Press the keys (only digits) of the desired code (5 digits)
f) Press key
g) Type in 00 (indicates the bistable operating mode)
h) Press the key corresponding to the desired type of
activation and visible indication:
-0- 2-digit activation. LED turned on for the entire activation
time
-1- 5-digit activation. LED turned on for the entire activation
time
-2- 2-digit activation. LED turned on for 10 s
-3- 5-digit activation. LED turned on for 10 s
74
(indicates that a previous code will be changed)
(indicates programming of an access code)
*
(indicates the end of access code)