Cutting Equipment; General Rules - RedMax GZ3500T Manuel D'utilisation

Mufer
The mufer is designed to keep noise levels to a minimum
and to direct exhaust fumes away from the user.
In areas with a hot, dry climate there is a high risk of res.
WARNING! The exhaust fumes from the
!
engine are hot and may contain sparks
which can start a re. Never start the
machine indoors or near combustible
material!
CAUTION! The mufer gets very hot during and after
use. This also applies during idling. Be aware of the re
hazard, especially when working near ammable
substances and/or vapours.
WARNING! Never use a saw without a
!
mufer, or with a damaged mufer. A
damaged mufer may substantially
increase the noise level and the re
hazard. Keep re ghting equipment
handy.

Cutting equipment

This section describes how to choose and maintain your
cutting equipment in order to:
• Reduce the risk of kickback.
• Reduce the risk of the saw chain breaking or jumping
off the bar.
• Obtain optimal cutting performance.
• Extend the life of cutting equipment.
• Avoid increasing vibration levels.

General rules

Only use cutting equipment recommended by us!
•
See instructions under the heading Technical data.
Keep the chain's cutting teeth properly
•
sharpened! Follow our instructions and use the
recommended le gauge. A damaged or badly
sharpened chain increases the risk of accidents.
Maintain the correct depth gauge setting! Follow
•
our instructions and use the recommended depth
gauge clearance. Too large a clearance increases
the risk of kickback.
12 – English
GENERAL SAFETY PRECAUTIONS
• Keep the chain properly tensioned! If the chain is
slack it is more likely to jump off and lead to increased
wear on the bar, chain and drive sprocket.
Keep cutting equipment well lubricated and
•
properly maintained! A poorly lubricated chain is
more likely to break and lead to increased wear on the
bar, chain and drive sprocket.
Cutting equipment designed to reduce
kickback
WARNING! Faulty cutting equipment or
!
the wrong combination of bar and saw
chain increases the risk of kickback!
Only use the bar/saw chain combinations
we recommend, and follow the ling
instructions. See instructions under the
heading Technical data.
The only way to avoid kickback is to make sure that the
kickback zone of the bar never touches anything.
By using cutting equipment with "built-in" kickback
reduction and keeping the chain sharp and well-
maintained you can reduce the effects of kickback.
Guide bar
The smaller the tip radius the lower the chance of
kickback.
Saw chain
A chain is made up of a number of links, which are
available in standard and low-kickback versions.
IMPORTANT! No saw chain design eliminates the
danger of kickback.
WARNING! Any contact with a rotating
!
saw chain can cause extremely serious
injuries.
Some terms that describe the bar and chain
To maintain the safety features of the cutting equipment,
you should replace a worn or damaged bar or chain with
a bar and chain combinations recommended by RedMax.
See instructions under the heading Technical Data for a
list of replacement bar and chain combinations we
recommend.