HQ Power LED Magic Bar VDPL404 Notice D'emploi page 3

• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, crash, etc. Using the device in an unauthorised way will void the warranty.
• The installation has to be approved by an expert before the device is taken into service.
• Connect the device to the mains with the power plug. Don't connect it to a dimming pack.
4. Installation
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable
norms.
• The carrying construction must be able to support 10 times the weight of the device for 1 hour without
deforming.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified
technician check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used... Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may result
in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 0.5 m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
5. Features
• easy mounting on a conventional speaker stand
• stand-alone, sound-control or DMX mode
• built-in microphone and sensitivity adjustment knob: the movement direction of the effect will reverse
on the beat of the music
• several internal programs controlled in auto or DMX mode
• DMX-controlled via 7 channels
• clear LED display for easy menu setting
• comes with protection bag for easy transportation
6. Overview
1 built-in microphone
2 rotary sensitivity control
3 LCD with MODE, UP and DOWN buttons
7. Operation
The projector starts running after connection to the mains. The LCD display [3] lights up and you can
choose the desired running mode using the MODE, UP and DOWN buttons [3] on the rear panel.
The projector has three running modes: stand alone, master/slave and DMX.
29.04.2010
VDPL404
4 XLR input and output
5 power supply input and fuse holder
3
©Velleman nv