Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Sound mode
•
Use the
and
the sound sensitivity (01~99).
DMX mode
•
Use the
and
DMX address (001~512) with the
•
Refer to §8: DMX mode for more information on DMX modes and channels.
Slave mode
•
Use the
and
chain when using auto-program 17. Must be set to a unique value on each slave.
Number of slaves
•
When using auto-program 17, set the number of slaves on the master to create a continuous
effect. Use the
Set software
•
Select when updating software.
Wait time
•
This is the time (0~5s) the slave waits to display the next colour scene. This also depends on the
number of slaves, e.g. when the number of slaves is set to 10 and the wait time to 3, the slave
will show the current scene for 30s to create a smooth effect.
8. DMX-mode
This mode allows you to control the fixture by any universal DMX controller.
•
All DMX-controlled devices need a digital start address so that the correct device responds to the
signals. This digital start address is the channel number from which the device starts to "listen"
to the DMX controller. The same starting address can be used for a whole group of devices or an
individual address can be set for every device.
•
When all devices have the same address, all the units will "listen" to the control signal on one
particular channel. In other words: changing the settings of one channel will affect all devices
simultaneously. If you set individual addresses, each device will "listen" to a separate channel
number. Changing the settings of one channel will only affect the device in question.
Example:
•
In case of the 7-channel VDPLOW1803RGB, you will have to set the start address of the first
unit to 1 (CH1~7), the second unit to 8 (1 + 7) (CH8~14), the third to 15 (8 + 7) (CH15~21),
and so on.
•
In case of the 11-channel VDPLOW1803RGB, you will have to set the start address of the first
unit to 1 (CH1~11), the second unit to 12 (1 + 11) (CH12~22), the third to 23 (12 + 11)
(CH23~33), and so on.
14.06.2011
VDPLOW1803RGB
buttons to set the sound program (01~16). Press the
buttons to set the DMX mode (01~05). Press the
and
buttons to set the slave ID (01~30). This indicates the 'position' of the slave in the
and
buttons to set the number of slaves (00~30).
buttons. Press the
button to confirm.
6
button to confirm and set
button to confirm and set the
©Velleman nv
Publicité
Table des Matières
