Electrolux EFME517S Instructions D'installation page 13

Electrical connection (non-Canada) - 4 wire cord
4-wire receptacle
(NEMA type 14-30R)
WARNING
ELECTRICAL SHOCK HAZARD
Failure to disconnect power source before
servicing could result in personal injury or even
death.
1. Turn off power supply to outlet.
2. Remove the screw securing the terminal block
access cover in the lower corner on the back
of the dryer.
3. Install a UL-approved strain relief
according to the power cord/strain relief
manufacturer's instructions in the power
cord entry hole below the access panel. At
this time, the strain relief should be loosely
in place.
4. Thread an UNPLUGGED, UL-approved, 30
amp. power cord, NEMA 14-30 type DRT or
SRDT, through the strain relief.
5. Disconnect the internal (WHITE) dryer
harness ground wire from the (GREEN)
ground screw next to the terminal block.
6. Attach the ground (GREEN) power cord
wire to the cabinet with the ground (GREEN)
screw. Tighten the screw securely.
7. Move the internal dryer harness ground
(WHITE) wire to the terminal block and
attach it along with the neutral (WHITE)
power cord wire conductor to the center,
SILVER colored terminal on the terminal
block. Tighten the screw securely.
8. Attach the RED and BLACK power cord
conductors to the outer, BRASS colored
terminals on the terminal block. Tighten both
screws securely.
WARNING
ELECTRICAL SHOCK HAZARD
Do not make a sharp bend or crimp wiring/
conductor at connections.
9. Follow manufacturer's guidelines for fi rmly
securing the strain relief and power cord.
10. Reinstall the terminal block cover.
Installation Instructions
30 AMP 30 AMP
NEMA 14-30 NEMA 14-30
NOTE
If a terminal screw falls during cord installation,
it can be retrieved in the terminal screw
recovery slot below the access panel.
Move internal ground (WHITE) Move internal ground (WHITE)
wire to neutral (SILVER) wire to neutral (SILVER)
terminal for 4-wire system. terminal for 4-wire system.
GREEN GREEN
ground screw ground screw
GREEN GREEN
ground wire ground wire
(WHITE wire) (WHITE wire)
Ground Ground
(GREEN wire) (GREEN wire)
Access cover Access cover
screw screw
Terminal Terminal
block block
Line 2 Line 2
(BRASS terminal) (BRASS terminal)
Neutral Neutral
(SILVER terminal) (SILVER terminal)
Line 1 Line 1
(BRASS terminal) (BRASS terminal)
Internal ground Internal ground
(GREEN screw) (GREEN screw)
Install Install
UL-approved UL-approved
strain relief here strain relief here
Terminal screw Terminal screw
recovery slot recovery slot
Neutral Neutral
terminal terminal
neutral wire neutral wire
power wire power wire
BLACK or BLACK or
RED power wire RED power wire
13
Neutral Neutral
WHITE WHITE
BLACK BLACK
or RED or RED