Set The Firecan Option; Set Node Address For Firecan - Fronius Acctiva Twin 15 A Instructions De Service

Set the FireCAN The FireCAN option enables a customer-specific FireCAN network to read out the 10 most
option recently stored service codes from the charger.
Set node address
1
for FireCAN -
1
-
2
IMPORTANT! After just 10 s the synergic line type set will be displayed. However, to set
the node address you should continue holding down the Start/Stop button until the set
node address appears.
-
-
IMPORTANT! An overview of the range of node addresses available for selection can be
found in the leaflet with the related node addresses for the FireCAN option.
3
56
Connect mains cable to charger and plug into mains
Charger in open circuit - ready indicator lights up
If mains power is not available, connect a charged battery to connection P1
Charger in standby mode - ready indicator is not lit
Press and hold Start/Stop button for approx. 15 s to retrieve the node address setting
The ready 24 V indicator goes off and the ready 12 V indicator remains lit - the charger
is in setup mode for the FireCAN node address
The set node address, e.g. node address 1, also appears on the monitor:
Press Start/Stop button to select a different node address