Performing Measurements; Continuous Measurement - TOOLCRAFT LDM 15J Mode D'emploi

10. Performing measurements

1. Point the laser at a right angle at the target and hold the device as
still as possible.
2. Press the ON/DIST button (C). Shortly, a beep sounds and the
reading is shown on the display.
3. After each measurement, the laser is deactivated and must be
reactivated before taking another measurement. To do so, press
ON/DIST button.

11. Continuous measurement

1. Press and hold the ON/DIST button (C) for approx. two seconds, in
order to switch to continuous measurement mode.
2. The targeting laser (B) is activated. The distance is measured
continuously.
3. The display will show the reading registered last during the current
measurement.
4. Press the ON/DIST button, in order to finish continuous measuring.
The last reading keeps showing in the display.
30