LGB 21761 Instructions De Service page 8

Smoke Generator
This model is equipped with a
smoke generator. A small supply
of LGB Smoke and Cleaning
Fluid is included with this model.
For best operation, fill the genera-
tor halfway with fluid. If the gen-
erator is overfilled, it will not con-
vert the fluid into smoke.
Attention! Only use LGB Smoke
and Cleaning Fluid (50010).
Other fluids may damage your
locomotive.
Attention! Never touch the heat-
ing element in the center of the
smoke generator. It is hot and
fragile.
Hint: The smoke generator can
be run "dry" without smoke fluid.
Power Supply
Attention! For safety and reliabil-
ity, operate this model with LGB
power supplies (transformers,
power packs and controls) only.
The use of non-LGB power sup-
plies will void your warranty.
Use this model with LGB power
supplies with an output of at least
1 amp. For more information on
LGB power supplies for indoor,
outdoor and multi-train operation,
see the LGB catalog.
Attention! After extended opera-
tion, this model may leave carbon
dust or other debris around the
track. This dust and debris can
stain carpet and other materials.
Consider this when setting up
your layout. Ernst Paul Lehmann
Patentwerk and LGB of America
are not liable for any damages.
SERVICE
Do-It-Yourself Service Levels
Level - Beginner
Level - Intermediate
Level - Advanced
Attention! Improper service will
void your warranty. For quality
service, contact your authorized
retailer or an LGB factory service
station (see Authorized Service).
Lubrication
The axle bearings and the side
8
rod ends should be lubricated
occasionally with a small amount
of LGB Maintenance Oil (50019).
Cleaning
This model can be cleaned exter-
nally using a mild detergent and
gentle stream of water. Do not
immerse this model.
Replacing the light bulbs
Front lanterns: Pull the socket
down and out of the lantern.
Remove and replace the bulb.
Reassemble.
Rear lanterns: Carefully pry the
lens away from the lantern. Using
tweezers, remove and replace the
bulb. Reassemble.
Cab light: Using tweezers, re-
move and replace the bulb.
Replacing
the smoke generator
- Pull the safety cover out of the
smoke stack (Fig. 3).
- Use pliers or tweezers to pull the
old smoke generator out of the
stack (Fig. 4).
- Cut the wires to the old genera-
tor and attach them to the repla-
cement generator.
- Insulate the connections and
push the replacement generator
into the stack (Fig. 5).
- Reassemble.
Replacing the traction tire
- Remove the hex head screw on
the drive wheel with the traction
tire.
- Remove the side rods from the
wheel.
- Use a small, straight-blade
screwdriver to replace the trac-
tion tire:
- Pry the old traction tire out of the
wheel groove.
- Gently insert the new traction
tire into the wheel groove.
- Make sure that the traction tire is
seated properly in the wheel
groove.