Homelite HLT26CDB Manuel D'utilisation page 32

For technical review, sent 3 Dec 2013.
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORISED SERVICE DEALER.
PROBLEM
Line will not advance.
Grass wraps round shaft housing
and bump head.
Bump knob hard to turn.
Lubricant drips from silencer.
English (Original instructions)
TROUBLESHOOTING
POSSIBLE CAUSE
Line welded to itself.
Not enough line on spool.
Line worn too short.
Line tangled on spool.
Engine speed too slow.
Cutting tall grass at ground level.
Operating trimmer at part throttle.
Screws threads dirty
damaged.
Operating trimmer at part
throttle.
Check lubricant/fuel mixture.
Air filter dirty.
17
SOLUTION
Lubricate with silicone spray.
Install more line. Refer to "Line Replacement"
earlier in this manual.
Pull lines while alternately pressing down on and
releasing bump head.
Remove line from spool and rewind. Refer to
"Line Replacement" earlier in this manual.
Advance line at full throttle.
Cut tall grass from the top down.
Operate trimmer at full throttle.
or Clean threads and lubricate with grease - if no
improvement, replace bump knob.
Operate trimmer at full throttle.
Use fresh fuel and the correct 2-stroke lubricant
mix.
Clean per instruction in Maintenance Section.