Homelite HLT26CDB Manuel D'utilisation page 31

For technical review, sent 3 Dec 2013.
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORISED SERVICE DEALER.
PROBLEM
Engine will not start.
Engine starts but will not accelerate.
Engine starts but will only run at
high speed at half choke.
Engine does not reach full speed
and emits excessive smoke.
Engine starts, runs, and accelerates
but will not idle.
Blade continues to rotate at idle
speed.
English (Original instructions)
TROUBLESHOOTING
POSSIBLE CAUSE
No spark.
No fuel.
Starter rope now harder to pull
than when new.
Engine requires approximately
three minutes to warm up.
Carburetor requires adjustment.
Check lubricant fuel mixture.
Spark arrestor screen is dirty.
Idle speed screw on carburetor
requires adjustment.
Carburetor requires adjustment.
16
SOLUTION
The spark plug may be damaged, remove it and
check for dirt and cracks. Replace with a new
spark plug.
Push primer bulb until bulb is full of fuel. If bulb
blocked. Contact a servicing dealer. If primer bulb
Remove spark plug, then turn the unit so the
spark plug hole is aimed at the ground.
Set the choke lever to position and pull starter
cord 10-15 times. This will clear excessive fuel
from the engine.
Remove any fuel from the product.
Clean and reinstall the spark plug.
Clean up any spilled fuel and move at least 9m
away before restarting.
Pull starter handle 3 times with the choke lever
at position.
If the engine does not start, set the choke lever to
choke position and repeat the normal starting
procedure.
If the engine still fails to start, repeat procedure
with a new spark plug.
Contact a servicing dealer.
Allow engine to completely warm up. If engine
does not accelerate after three minutes, contact a
servicing dealer.
Contact a servicing dealer.
Use fresh fuel and the correct 2-stroke lubricant
mix.
earlier in this manual.
Contact a servicing dealer.
Contact a servicing dealer.
Contact a servicing dealer.