Riello Elettronica Cardin T624 Notice D'emploi page 52

I GB
13
M1
14
M1 END PROG.
ADVANCED PROGRAMMING (manual) WITH SINGLE GATE LEAF AUTOMATION
DIP 9 ON DURING programming for a self-learning cycle that decelerates after 5 seconds so it can find the mechanical travel
limit safely. Use this setting for long and/or heavy.
DIP 9 OFF DURING programming for rapid mechanical travel limit detection (without deceleration).
Before starting programming check the correct setting and connection of the inputs using the status leds (part. 22, fig. A):
Leds BSC, BSA, FT1, FT2, J2 and STP must be ON.
Leds J1, PC, PA, PED and P/P must be OFF.
M1
2
PROG. P3 P/P
STOP
3
M1
4
M1
5
M1
6
M1
PAUSE
7
TIME
M1
51
When the gate with M2 reaches the closing travel limit, the other motor M1 will move.
After this point we can manually insert the deceleration start points using P/P (DIP 9 set
to ON) the motor will stop for a second then start again. Otherwise wait until the gate
reaches the travel limit.
M2
When the gate with M1 has closed completely, the motor will stop, led LD1 will switch off and
the ECU will quit programming.
Checks: force, times and stopping points. We advise you to consider inserting deceleration
points (DIP 9 set to ON) to reduce impact against the travel limits so reducing wear and tear on
the mechanical parts.
M2
Repeat programming if you have modified the mechanical travel limits.
Switch off the power to the ECU.
Release the motor and move the gate to the position "almost open".
Re-engage the motor and switch on the power to the installation.
Hold down the PROG button (part. 15, fig. A) for about 3 seconds until led LD1
lights up (part. 18, fig. A)
LD1
The ECU is now in the programming stage.
Press the P/P button (part. 17, fig. A) the gate should begin to close, if it moves in
the opening direction instead, stop programming by switching off the power, invert
the wires of the motor and repeat the procedure from point (1).
If the motor stops before reaching the travel limits increase the torque level
using the trimmer.
After having found the M1 closing travel limit it will open automatically.
At this point you may manually insert the DECELERATION start point using
P/P if DIP 9 is set to ON. The motor will stop for a second and then begin to
move again.
When the gate has completed the opening cycle (and has arrived at the
mechanical stop) pause time memorisation will start (if automatic reclosing is not
required move directly to point (8).