Riello Elettronica Cardin T624 Notice D'emploi page 47

Function n.
OFF
OFF
ON
OFF
3
JOLLY
INPUT MODE
4
OFF
ON
ON
ON
OFF
5
PREFLASH
OFF
RE-CLOSURE
6
TIMER
OFF
7
US1 OUTPUT
OFF
GATE
8
RELEASE
JOLT
OFF
9
SLOWDOWN
OFF
POWER
10
CLOSING
JOLT
OFF
11
1 - 2 MOTORS
OFF
RECLOSING
AFTER THE
12
PHOTOELECTRIC
CELLS
Off - On Mode
J1 = TIMER
J2 = FT3
J1 = FCA M1
J2 = FCC M1
J1 = FCA M1
J2 = FCA M2
J1 = FCA M1
J2 = FCC M1
PA = FCA M2
PC = FCC M2
EXCLUDED
ON INSERTED
EXCLUDED
ON INSERTED
Dry contact
ON Channel 2 (OC2)
EXCLUDED
ON INSERTED
EXCLUDED
ON INSERTED
EXCLUDED
ON INSERTED
1 MOTOR
ON 2 MOTORS
EXCLUDED
ON INSERTED
J1=TIMER input; closes the gate when the contact is opened and
opens it when the contact is closed.
J2=third photocell input (FT3); intervenes only during opening and
forces closing. Use N.C. contacts.
Stops only motor M1 using electric travel limits.
Use N.C. contacts
Motors are stopped during OPENING using electric travel limits.
Use N.C. contacts
For installations with 4 travel limits. Connect the travel limits of motor M1
to the inputs FCC and FCA. Connect the travel limits of motor M2 to the
inputs J1 and J2.
Use N.C. contacts
The flashing light operates together with the motor.
The flashing light operates 5 seconds before any operation.
After one complete opening, the control unit only closes again with a
manual control.
After one complete opening, the control unit closes automatically after the
programmed pause time.
This contact gives information regarding the status of the gate.
The relay activates as the gate begins to open and deactivates only
after complete closing has been achieved.
Second radio channel output. If you don't use this function the second
radio channel will activate pedestrian opening.
Function excluded.
The gate release jolt is needed to release the electric lock.
The gate with M1 installed will carry out a brief closing movement before
starting the opening cycle.
There is no slowdown in the last part of travel.
With the slowdown function connected, the motor halves its speed towards
the end of every gate movement.
Power closing is not carried out.
The ECU will end the closing manoeuvre with a brief increase to full power
on motor M1.
Only the M1 output is enabled. The pedestrian command partially opens
and closes motor M1
Enables both motor outputs (M1 and M2). The pedestrian command
completely opens and closes the gate with motor M1.
Function excluded.
The activation of photoelectric cell reduces the pause time for whatever
is value previously was to 2 seconds.
Descrption
GB
46