Menu Overview - TESTO 175 Mode D'emploi

7 Using the product

7.3. Menu overview

The menu overview shows exemplary display
representations of the data logger testo 175-T2.
The display must be switched on to be able to show
the corresponding indications. This is accomplished
with the software testo ComSoft.
The indication in the display is updated according to
the programmed measurement rate. Only readings
from active channels are displayed.
The channels are also activated via the software
testo ComSoft.
The symbols for upper or lower alarm value light up
in operating states Rec and End, if the programmed
alarm value has been exceeded or fallen short off.
After 10 seconds without operating a key the
display will return to its initial state.
48