Table des Matières
Publicité
STRAIGHT STITCHING
Straight stitch is most frequently used for every aspect of
sewing. Let's learn how to sew following the steps below.
1. SETTINGS
Presser foot - General Purpose Foot
Thread tension control - AUTO
NOTE: Based upon the weight of the fabric, slight "fine
tuning" of the tension may be desired.
A. Thread tension control
B. Twin needle mode switch
C. Reverse stitch switch
D. Presser foot lifter
E. Stitch length control
F. Stitch width control
2. Pull both threads under the presser foot toward the back of
the machine, leaving about 6" (15cm) clear.
3. Place the fabric under the presser foot and lower the presser
foot lifter.
4. Turn the hand wheel toward you until the needle enters the
fabric.
5. Start the machine. Guide the fabric gently with your hands.
When reaching the edge of the material, stop the sewing
machine.
NOTE: The Needle Plate has both Metric and Inch
Markings as an aid for guiding your fabric when sewing
a seam.
6. First turn the handwheel toward you until the needle is at its
highest position, then raise the presser foot, draw materials
to the rear and cut off excess thread with the thread cutter
located on the bottom of face cover as shown.
NOTE: To secure the stitching and avoid raveling, press
the reverse stitch switch and sew a few stitches at the
start and end of the seam.
42
1
A
B
C
D
2
5
6
E
F
4
3
Publicité
Table des Matières
