Toto TLK07001G Manuel D'installation Et Guide D'utilisation page 8

1. Insert the dispenser into the
installation holes in the counter
(or the sink).
2. Secure the dispenser with
washer and hex nut.
Caution
Make sure that the cords and
tubes do not get crimped.
INSTALLATION PROCEDURE - Controller
Marking of the positions of the screw holes for the anchoring plate.
Decide the anchoring position of the controller and mark the positions of screw holes on the wall by
referring to the dimensional drawing.
[ 0.8 gallon (3L) Tank Type ]
Reference
anchoring screw
3 - 3
/ 4 ' '
( 9 4
m m
)
1 - 7
Installing the controller on a tiled or concrete wall
1. Drill a rough hole at the screw hole position
and drive in the curl plug (procure in the field).
* Procure a curl plug that matches the screw
(Φ 5.1 mm x 32 mm).
2. Anchor the bottom anchoring plate to the
controller with one countersunk tapping screw.
Caution
 Do not tighten the screws with an electric
screwdriver.
These should be tightened manually.
 Pay attention not to confuse the top side and
the bottom side of the anchoring plate.
INSTALLATION PROCEDURE - Spout
Dispenser
Washer
Sensor cord
Liquid soap
hose (clear)
5 - 7
/ 8 ' '
( 1 4
9 m
m )
/ 8 ' '
( 4 7
m m
)
Packing
Packing
Hex nut
Air hose
(blue)
[ 0.26 gallon (1L) Tank Type (special order)]
7 / 8
( 2 1
2 - 1 3
' '
m m
( 7 0
)
5 - 7
( 1 3 / 1 6
8 m ' '
m )
Reference
anchoring screw
Anchor
Controller (Back side)
Anchoring plate
Anchoring plate
Countersunk tapping screw
(Φ 4 mm x 10 mm)
8
Dispenser
Packing
Sensor cord
(Unit: Inch (mm))
/ 1 6 '
'
3 - 3
m m
/ 4 ' '
)
( 9 4
m m
)
5 - 7
/ 8 ' '
( 1 4
9 m
m )
1 - 7
/ 8 ' '
( 4 7
m m
)
Countersunk
tapping screw
(Φ 4 mm x 10 mm)
Top side
Washer
Hex nut
Air hose (blue)
Liquid soap
hose(clear)
Bottom side