Problem/Solution - Beaba Milkeo Mode D'emploi

5. Rinse and clean the powder
6. Do not use a hard brush, organic abrasive products, or organic solvents to clean the mixing compartment
7. Before storing the product, empty and clean the powder reservoir and the water reservoir. To empty any excess water
in the circuit, remove the water tank, press the cleaning button for 5 seconds to drain the water circuit. To restart the
product press the start button

10. Problem/Solution

Problem
The product does not work The
control screen is not switched on.
Nothing happens when
I press the buttons
The product stops working
when in use
No powder is dispensed during bottle
preparation
During preparation, the dispenser
wheel does not rotate
16
1 2
and water reservoirs regularly. Use the bottle brush to remove powder in the corners.
3
Possible causes
The product is not plugged in
The power button is off
The product enters locked mode automatically or manually
There is not enough water in the water reservoir and the water
volume icon is flashing slowly
Mixing compartment is incorrectly installed or not installed
The water reservoir is not installed or is incorrectly installed
The water in the reservoir is too hot (>35°C) and the tempera-
ture icon is flashing
The volume of water in the reservoir has become too low during
preparation
The mixing compartment comes off during preparation
During preparation, the temperature in the heating system
exceeds the value entered. The product switches to
protection mode
There is no powder or not enough powder in the reservoir
The reservoir is installed incorrectly
The dispenser wheel is incorrectly installed
The reservoir is installed incorrectly
Possible solutions
Plug in the product
Press the power button
Unlock the product by pressing the unlock button
Add water to the reservoir
Reinstall the mixing compartment and ensure that it is
properly in place
Reinstall the water reservoir and ensure that it is properly
in place
Replace the water in the reservoir with water under 35°C
Add water to the reservoir
Install the mixing compartment correctly
Press the hot water dispenser button, the appliance will
release water and restore itself
Add powder to the powder reservoir
Reinstall the powder reservoir
Reinstall the dispenser wheel
Reinstall the powder reservoir
5