Switching On The Product - Beaba Milkeo Mode D'emploi

3. Switching on the product

- Pour the water into the water reservoir
- Pour the powder into the powder reservoir
- Plug in the product
- Press the power button.
3
- When using for the first time, remove the powder reservoir, place an empty bowl on bottle stand, start the auto-clean cycle by
pressing the button. At the end of the cycle put on the powder reservoir.
- If you do not use the product for a period of 3 minutes, the control panel locks automatically. To unlock it, press the lock/
unlock button for 1,5 seconds
- You can lock the control panel manually by pressing the lock/unlock button for 1,5 seconds
4. Configuration for the first bottle
When using for the first time, it is necessary to configure the product. For this, it is necessary to:
- Press once on the settings button
- The temperature icon flashes
- Press again on , the water quantity icon flashes
- Press again on , the powder quantity icon flashes
about the quantity of power, follow the indications in the next section.
- Press the settings button
- Place the bottle on the bottle stand
- Press the bottle preparation button
The settings will be saved for the following bottles. Repeat the operation to change the settings. If you modify the quantity
of water, the quantity of powder is adjusted automatically to keep the same ratio.
2
1
Set the desired temperature with the + and – buttons
and define the quantity of powder required. For information
to confirm
4
selecting one of the two heights according to the size of the bottle
to prepare a bottle.
and define the quantity of water required.
13