Using And Replacing The Joint Brush; User Information; Replacing The Joint Brush - Gloria MULTIBRUSH Mode D'emploi

NOTE!
For cleaning wood surfaces use the
soft surface brush with the yellow /
black bristles.
This is available as a GLORIA accesso-
ry and is not in cluded in the scope of
delivery.
Assembly and operating instructions
can be found in the product informa-
tion "Surface brush for wood
surfaces".
7.1.6 Using and replacing the
joint brush
Figures 21 - 23
Assemble the joint brush as described
21
in Chapter 7.1.3. Place the device
parallel with guiding wheel and joint
brush on the joint to be treated. Hold
the device at working angle and make
sure that the rubber lip on the safety
guard (H) is just above the ground.
NOTE!
To adjust the safety guard (H), turn the
22
7 click-stop safety guard to the posi-
tion described under point "21".
Align the joint brush with the centre of
23
the joint, walk at an even steady pace and
push the device in front of you. Adapt
your pace of work to the degree of soiling.
NOTE!
Always work along the joint and hold
the device away from your body.
In cases of stubborn dirt you can
move the device backwards and
forwards on the spot (like a scrubber),
until the required result is achieved.
CAUTION! RISK OF INJURY FROM
RUNNING BRUSHING TOOL!
Never lift the device off the ground
whilst switched on during work as
there is danger of entanglement!

7.2 User information

Do not remove any wet weeds with
the device.
Never clean wood decks or wood
terraces with the joint brush.
Only clean joints that are intact.
Damaged or crumbling joints or joints
with cracks should not be cleaned
with the device.
Rinse the cleaned surfaces thoroughly
after cleaning.
Worn brushes i.e. frayed wire bristles
should be replaced in good time.
To prevent damaging the device, it is
essential that the joint brush is replaced
when the diameter is < 90 mm.

7.3 Replacing the joint brush

Figures 24 - 28
Switch off the device and remove the
battery (C).
Open the locking device (K)
24
the joint brush unit (J), as shown in
the illustration, and remove the joint
brush unit.
Unscrew the hexagon socket screw
25
3-4 turns so far out of the joint brush
housing, until safety guard (H) can
easily be twisted and pulled off.
Now press lock button (Q) which
26
blocks the drive shaft and unscrew the
hexagon socket screw, which fixes the
joint brush (J), from the drive shaft
( ).
Remove the disc from the joint brush.
ATTENTION! Improper use of the
device poses a risk of damage to
property!
You should therefore observe the
following safety instruction:
33
of