Using The Surface Brush On Wood Surfaces; Using And Replacing The Joint Brush; User Information; Replacing The Joint Brush - Gloria MultiBrush SpeedControl Mode D'emploi

RZ_MULTIBRUSH_DE_GB_FR_NL_978410-1_Text_GB 10.11.16 15:55 Seite 28
CAUTION! RISK OF INJURY FROM
RUNNING BRUSHING TOOL!
Never lift the device off the ground
whilst switched on during work as
there is danger of entanglement!
6.1.4 Using the surface brush
on wood surfaces (optionally
available as an accessory)
ATTENTION! Improper use of the
device poses a risk of damage to
property! You should therefore
observe the following safety
instructions:
Never use the hard surface brush
with the black bristles for cleaning
wood surfaces, as the hard bristles
attack the surface of the wood,
thereby damaging it.
NOTE!
For cleaning wood surfaces use the
soft surface brush with the yellow /
black bristles.
This is available as a GLORIA accesso-
ry and is not in cluded in the scope of
delivery.
Assembly and operating instructions
can be found in the product informa-
tion "Surface brush for wood
surfaces".
6.1.5 Using and replacing the
joint brush
Figures 22 - 24
Assemble the joint brush as described
22
in Chapter 6.1.2. Place the device
parallel with guiding wheel and joint
brush on the joint to be treated. Hold
the device at working angle and make
sure that the rubber lip on the safety
guard (H) is just above the ground.
NOTE!
To adjust the safety guard (H), turn the
23
7 click-stop safety guard to the posi-
tion described under point "22".
Align the joint brush with the centre of
24
the joint, walk at an even steady pace and
push the device in front of you. Adapt
your pace of work to the degree of soiling.
NOTE!
Always work along the joint and hold
the device away from your body.
In cases of stubborn dirt you can
move the device backwards and
forwards on the spot (like a scrubber),
until the required result is achieved.
CAUTION! RISK OF INJURY FROM
RUNNING BRUSHING TOOL!
Never lift the device off the ground
whilst switched on during work as
there is danger of entanglement!

6.2 User information

Do not remove any wet weeds with
the device.
Never clean wood decks or wood
terraces with the joint brush.
Only clean joints that are intact.
Damaged or crumbling joints or joints
with cracks should not be cleaned
with the device.
Rinse the cleaned surfaces thoroughly
after cleaning.
Worn brushes i.e. frayed bristles
should be replaced in good time.
Switch off the device, before starting
with the next cleaning course (e.g.
wood decks).

6.3 Replacing the joint brush

Figures 25 - 29
Switch off the device and disconnect the
power cord (C) from the power supply.
28