4
Technical data
MultiBrush li-on
Battery
Type:
Nominal voltage:
Rating:
Charging station
Input voltage:
Output voltage:
Rating:
Battery charging time:
Dimensions & Rotational speeds
Device width:
Device height (min):
Device height (max):
Rotational speed of joint brush:
Rotational speed of surface brush:
Device weight with joint brush:
Device weight with surface brush:
Hand-Arm vibration value:
Sound pressure level L PA :
Sound power level L WA :
Protection class:
5
Assembly
Figures 1 - 6
NOTE!
Your device is supplied with the
1
surface brush pre-assembled.
Loose parts supplied must be
as sembled accordingly when working
with the joint brush.
After removing from the packaging,
loosen screw connection (G)
Next, turn handle (A) 45° as shown in
fig ure
and adjust the length of
3
the telescopic tube (F) according to
your body height, as illustrated.
5 locking positions are available.
In the selected position, turn handle
4
(A) a further 45° and tighten the
height of the telescopic tube (F) with
the screw connection (G) by hand.
Lithium-ion
18.0 V
4.0 Ah
100-240 V~ / 50/60 Hz
12-20 V / 4.0 Ah
4.0 Ah
35 - 75 Min.
Surface brush 24.0 cm // Joint brush 28 cm
Surface brush 1.15 m // Joint brush 1.04 m
Surface brush 1.35 m // Joint brush 1.24 m
1000 rpm to 1400 rpm
700 rpm to 950 rpm
2.7 kg without battery / 3.4 kg with battery
3.4 kg without battery / 4.1 kg with battery
< 3.1 m/s
77 dB
90 dB
II
6
.
2
28
(+/- 1.5 m/s
)
2
2
As the device should always be
guided and operated with two
hands, fit the additional handle (E) as
shown in the figure
5
height and screw the additional
handle (E) tightly into place
Prior to initial commissioning
WARNING! BEFORE USE OBSERVE
CHAPTER 2 "FOR YOUR SAFETY".
You should therefore observe the
following safety instructions:
The mains voltage must be in com-
pliance with the voltage specifica-
tion (V~) on the type plate of the
charger.
Use only the supplied charger with
corresponding original Li-Ion bat-
tery. Operate charger only in dry
rooms.
, adjust the
.
6