Assembly Of The Brushing Tools; Using The Side Brush For Double-Sided Cleaning - Gloria 000293.000 Mode D'emploi

RZ_POWERBRUSH_DE_GB_FR_NL_978466-02.qxp_Text_GB 15.01.18 14:21 Seite 24
Never clean if others, in particular
children or animals, are in the area!
Never use the device in the rain.
You can regulate the speed of the
10
brush by pressing the speed control
on the adjustment wheel (O).
Speed recommendations for GLORIA brushes
Position 1-3
Position 4-6
Hold the device securely by the
11
handle (A) and additional handle (E)
and switch on the device by pressing
and holding the ON/OFF safety
switch (D) in handle (A).
Place the switched-on device parallel on
12
the surface to be treated and push the
device in front of you (see 6.1.2 to 6.1.4
for more operating instructions).
In case of work interruptions or
danger, release the ON/OFF safety
switch (D) immediately.
6.1.1 Assembly of the brushing
tools
Figures 13 - 15
ATTENTION! RISK OF INJURY
During assembly or conversion work, it
is possible to injure yourself on the bris-
tles. It is therefore important to observe
the following safety instructions:
Wear protective gloves during
assembly!
Assembly of the side brush with addi-
tional safety guard
Switch off the device and disconnect
the power cord (C) from the power
supply.
soft brushes (wood brush)
harder brushes (stone brush)
Fix the surface brush (M) by using one
13
hand to secure this against twisting.
Then fully unscrew the screw as shown.
For this purpose, use the hexagon
socket screw provided. Now remove
the internal adapter (K).
NOTE
It is essential to store the internal
adapter (K), as this is subsequently
required for the assembly of the sur-
face brush (M).
Attach the additional safety guard (I) to
14
the adjustable safety guard (L) as shown.
Insert the side brush (J) into the hexagon
15
socket of the surface brush. Fix the sur-
face brush by using your hands to secure
this against twisting and use the screw to
securely screw the side brush onto the
surface brush (M). For this purpose, use
the hexagon socket screw provided.
The side brush is now successfully
assembled.
6.1.2 Using the side brush for
double-sided cleaning
Figures 16 - 22
NOTE
Your device is equipped with a func-
tion that supports the cleaning of
ground surfaces all the way up to the
kerb and enables terrace and/or
ground surfaces located at the edges
of houses or walls to be cleaned right
up to the corners.
Place the device parallel with the sur-
16
face and side brush on the surface to be
treated. Hold the device at working
angle and make sure that the brush
strip on the safety guard (L) is just
above the ground and that the bristles
24