Attaching The Front Handle - GreenWorks Tools GD40BC Manuel D'utilisation

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SV HR HU RO BG EL AR TR HE LT LV ET
WARNING
Do not attempt to modify this product or create
accessories not recommended for use with this product.
result in a hazardous condition leading to possible
serious personal injury.
WARNING
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from the
product when assembling parts.
ATTACHING GRASS DEFLECTOR
See Figure 2.
WARNING
Avoid contact with the blade. Failure to avoid contact can
result in serious personal injury.
Invert the string trimmer to access the trimmer head.
■
Using a Phillips head screwdriver, remove the
■
preinstalled screws (a) from the trimmer head.
Place the guard (b) on to the trimmer head and slide
■
the guard onto the head by following the track on the
head.
Align the screw holes on the guard with the screw holes
■
on the trimmer head.
Insert the screws into the trimmer head, fastening the
■
guard in place.
Place the guard cap (c) on to the guard and slide the
■
guard cap onto the guard.
Align the screw holes on the guard cap with the screw
■
holes on the guard.
Insert the screws into the guard, fastening the the
■
guard cap in place.
WARNING
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
WARNING
Always wear eye protection. Failure to do so could
result in objects being thrown into your eyes resulting in
possible serious injury.
English (original instructions)
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
INSTALLING AN ATTACHMENT TO THE POWER HAED
See Figure 3.
Loosen the attachment knob (19) on the coupler (10).
■
Push in the release button located on the lower tube (18).
■
Align the button with the positioning hole on the power
head coupler.
Slide the lower tube in to the power head coupler until
■
the release button engages in the positioning hole.
Tighten the attachment knob securely.
■

ATTACHING THE FRONT HANDLE

See Figure 4.
Install the main handle onto the shaft, place the bar on
■
the top of main handle, making sure the bar is pointing
left while holding unit.
Place the clam on the back side of the main handle
■
onto shaft.
Take 2 bolts provided and secure the bolts to clamp
■
with Philips screw driver (not provided).
2
WARNING