Complete Installation - Maytag BRAVOS Guide D'utilisation Et D'entretien

5. Next, place the level on the side of the washer in the crease between the top of the
washer and the cabinet.
6. If the washer is not level, move the washer out slightly, tip back, prop up the front of the
washer on a wood block. Adjust the feet up or down as necessary by twisting the feet.
Repeat steps 1 through 5 until washer is level.
7. Use a ⁄ " or 14 mm open-end wrench to turn the locknut counterclockwise on the foot
9
16
tightly against the washer cabinet.
IMPORTANT: If the locknut is not tight against the washer cabinet, the washer may
vibrate.
Level the side.

Complete Installation

1. Check the electrical requirements. Be sure that you have the correct electrical supply and
the recommended grounding method. See "Electrical Requirements."
2. Check that all parts are now installed. If there is an extra part, go back through the steps
to see which step was skipped.
3. Check that you have all of your tools.
4. Keep the foam packing ring from the washer tub for future relocation of the washer.
Dispose of/recycle all packaging materials.
5. Check that the water faucets are on.
6. Check for leaks around faucets and inlet hoses.
7. Plug into a grounded 3 prong outlet.
8. Remove any protective film or tape remaining on the washer.
9. Read "Washer Use."
10. To test and to clean your washer, measure
recommended amount of High Efficiency (HE) powdered or liquid detergent for a medium-
size load and pour it into the detergent dispenser. Close the lid. Press
POWER/CANCEL. Select a normal cycle and press START/PAUSE. Allow it to complete
one whole cycle.
⁄ of the detergent manufacturer's
1
2
11