Indicator Lights; Water Use - Maytag NEPTUNE TL Guide D'utilisation

O I
PERATING
Step 7
S Y
TART OUR
• Add detergent and additives to the dispensers (See pages 7-8).
• Close the lid.
• Press the Start/Pause pad.
NOTES:
• When the cycle is complete, the Locked light will go out.The lid will
open easily. DO NOT attempt to open the washer when the Locked
light is illuminated.To add a forgotten item, see page 3.
• When the washer is started after a pause, there will be a pause of up
to 20 seconds before continuing the cycle.
• Pressing Off cancels the cycle and stops the washer.
• Some cycles are designed to tumble then pause.This is normal.
E
STIMATED
When setting the cycle and pressing Start/Pause, the display will show the
estimated minutes remaining in the cycle.The estimated time remaining may
fluctuate to better indicate the wash time left in the cycle.
I
NDICATOR
Locked – lights whenever the lid of the clothes washer is locked.The lid can
be unlocked by pressing the Start/Pause pad to pause the washer.
Pad Indicator Lights – the indicator lights next to the pads will illuminate
when the pad is selected.
Cycle Status Lights – the Cycle Status Lights will illuminate to indicate
where the washer is in the selected cycle.
W U
ATER SE
The amount of water used will vary with each load.The Maytag Neptune
matically provide the appropriate amount of water for efficient cleaning performance and conservation of water and energy. Fill
time will vary depending on water pressure.
NSTRUCTIONS
M N
AYTAG EPTUNE
T D
IME ISPLAY
L
IGHTS
TL W
®
ASHER
® TL clothes washer uses an adaptive fill system to auto-
6