Petsafe PFD19-16861 Guide De Démarrage Rapide page 5

Setup and Assemble Feeder
1. Remove the components that are located inside the
food hopper.
2. We recommend you wash and rinse the bowl, the bowl
holder, food hopper, lid and conveyor. Once the parts
are dry, ensure a conveyor belt lip is aligned with the
arrows on the side. Replace the conveyor and the
food hopper.
3. Plug in the power adaptor. If you want, install four (4)
D-Cell alkaline batteries in case of a power outage.
The LED will blink yellow indicating that the feeder is on
and it is in setup mode.
4. Place the bowl into the bowl holder. Lift the feeder and
slide the holder notch into the groove on the bottom of
the feeder.
Batteries are for back-up power
only and should not be used as
the main power source.
petsafe.com 5