Memory; Displaying Stored Results - Medisana SL 100 CONNECT Mode D'emploi

The blood pressure indicator
bar depending on the WHO blood pressure classification. If the unit has
detected an irregular heartbeat, the arrhythmia display
additionally.
7.
The readings are automatically saved in the selected memory (
except if a guest mode measuement has been finished (see chapter 3.4
Setting up the user memory). Up to 500 measured values with date and
time can be stored in each memory.
8. The measurement results will automatically be transferred via Bluetooth
to receiveready devices. During this process, the Bluetooth-symbol
will flash. If the transfer was successful, the Bluetooth-symbol
appear together with "OK" in the display. If the transfer was not success-
ful, "Err" will appear.
9.
The unit switches off automatically after approx. 1 minute if no buttons
are pressed. The unit may also be switched off using the START/STOP
button .

4.3 Transfer via Bluetooth to VitaDock online resp.
VitaDock app
®
The MEDISANA Wrist blood pressure monitor SL 100 connect offers
the possibility to transfer your measured values via Bluetooth to the Vita-
Dock online portal resp. to the VitaDock app. These VitaDock ®
cations allow the evaluation, storage and synchronisation of your data
between multiple iOS- and Android-devices to have access to it anytime
and anywhere. You may share your results with your friends or your doc-
tor. Therefore you need a free user account, which you can create on the
website www.vitadock.com. For Android or iOS mobile devices, you may
download the respective apps. You will find a detailed instruction for how
to install and use the software on the mentioned website. After each blood
pressure measurement an automatic transfer will be initiated by the device
- Bluetooth therefore should be activated and configured on the receiving
device(s). If you want to transfer the stored values from your SL 100
connect manually, please follow these steps:
1. Press and hold START/STOP-button
the manual transfer mode.
2. The Bluetooth-symbol
3. If the transfer was successful, the Bluetooth-symbol
together with "OK" in the display. If the transfer was not successful,
"Err" will appear.

5 Memory

5.1 Displaying stored results

You can store up to 500 readings (blood pressure and pulse rate with the
time and date) in either one of the two memories in your blood pressure
monitor. The measured values are stored automatically. Press the M-but-
ton to call up the measured values stored. The average values of the

last 3 measurements of the respective user appear on the display. Press
4 Operating / 5 Memory
flashes next to the relevant coloured

®

flashes and the transfer begins.


®
for 3 seconds, to enter
will appear

GB
appears
i
or ),
i
i

will

i
® appli-
i
i
25