Wall Clamps For Super Erecta Wire Shelf
Wall clamps are required on stationary shelving units that measure 14" (355mm) deep and are taller than 63" (1600mm).
Acceptable configurations of 14" (355mm) deep shelving with 74" (1895mm) posts that do not require foot plates or wall clamps.
"L" Configuration with one
4-post shelving unit and
one Add-on 2-post unit
connected with "S" Hooks.
Configurations of 14" (355mm) deep shelving
that REQUIRE wall clamps.
Larger "L" configurations that have linear runs as part of it.
* Save this document for future application, load rating and/or safety reference.
"U" Configuration with one 4-post shelving
unit and two additional Add-on 2-post units
connected with "S" Hooks as shown.
Configurations of 14" (355mm) deep shelving that REQUIRE wall clamps.
Any stand-alone single unit, end-to-end configurations, or configurations with linear runs.
US/Can: 1.800.992.1776
Corporate Headquarters (US): 1.570.825.2741
For Inquiries Outside of the U.S. and Canada, Visit www.metro.com/contactus
All Starter Units MUST have four posts.
All Add-On Units MUST have 2 posts and 2 "S" Hooks.
All Add-On Units MUST have a minimum of one open collar
All "S" Hooks must be located as close to the shelf collars as
All other configurations of 14" (355mm) shelving not
shown REQUIRE use of wall clamps.
2
2
www.metro.com
www.metro.com
www.metro.com
"U" Configuration with one 4-post shelving unit
and three Add-on 2-post units connected with
"S" Hooks as shown.
Starter/Add on guidelines
adjacent to a post on the Starter Unit.
possible.
No casters!
INSTR-WCLAMP-N
INSTR_FOODBANK
07/2018
INSTR-WCLAMP-N