Set switching point of Soil
Moisture Sensor :
H
J
Display soil moisture :
H
J
Usage :
6. Putting into Storage
Storage /
Overwintering :
Disposal :
(in accordance with
RL 2002 / 96 / EC)
Increase soil moisture level :
v If the soil seems too dry for an application (type of soil or plant
species), turn the switching controller
"Damp" (e.g. with a coin).
Reduce soil moisture level :
v If the soil seems too damp for an application (type of soil or
plant species), turn the switching controller
towards "Dry" (e.g. with a coin).
K
The soil moisture can be displayed at any time with the Soil
Moisture Sensor. When the Soil Moisture Sensor shows
I
K
"Damp"
, watering is not carried out.
v Press indicator button
The soil moisture value last measured is indicated for 1 minute
with the relevant LED ( "Dry"
During the minute in which the measured result is displayed, the
switching controller can be used to find the relevant switching
point by turning the switching controller until the display changes
from "Dry"
not change, the ground is either very dry or very damp.
K
To keep the soil moisture level as constant as possible, irrigation
should be carried out with short watering cycles and short
watering times. This especially applies to flower boxes on
balconies, which have a watering time of < 5 min.
The storage location must not be accessible to children.
1. Remove batteries from the Soil Moisture Sensor and Water
Timer.
2. Store Water Timer and Soil Moisture Sensor in a dry place
protected from frost.
Important !
Return spent batteries to one of the sales outlets or dispose of
batteries via your municipal recycling collection centre.
Only dispose of battery once discharged.
The product must not be added to normal household waste. It
must be disposed of in line with local environmental regulations.
v Important: Make sure that the unit is disposed of via your
municipal recycling collection centre.
I
.
J
or "Damp"
J
K
to "Damp"
or vice versa. If the display does
H
to the right towards
H
to the left
K
).
9