Accessories - Gardena A 1020 Sensor Mode D'emploi

Fault
Watering is not switched on
although soil is dry
Watering is switched on
although soil is damp
Automatic Irrigation Set
does not close
Battery display of Soil
Moisture Sensor flashing
Error indicator of
Water Timer flashing
In the event of other faults please contact GARDENA Service.
A
Repairs should only be carried out by GARDENA service centres or dealers
authorised by GARDENA.

9. Accessories

GARDENA Extension Cable
(length : 10 metres)
GARDENA sensor tip
with felt
12
Possible cause
Valve has been closed manually.
The control panel has not been
inserted correctly.
Soil Moisture Sensor not
positioned in watering area.
Switching controller too far
to the right on "Damp".
Defective or loose sensor cable.
Air trapped at sensor tip.
Minimum flow rate below
below 20 l / h.
Batteries of Soil Moisture
Sensor spent / inserted
incorrectly / wrong batteries
used.
Soil Moisture Sensor defective.
Batteries of Soil Moisture
Sensor spent / inserted
incorrectly / wrong battery
used.
Batteries of Soil Moisture Sensor v Replace batteries of Soil
are flat.
Cable of Soil Moisture Sensor
defective.
Defective or loose sensor cable.
Used to extend sensor cable to
max. 105 metres.
For replacement of damaged
sensor tip.
Remedy
v Turn Run Time button to a
watering duration.
v Insert control panel
correctly.
v Position Soil Moisture
Sensor in watering area.
v Turn switching controller to
the left accordingly.
v Check sensor cable and
connections.
v Remove trapped air (see
4. Initial Operation " "Plant"
Soil Moisture Sensor " ).
v Connect more drip heads.
v Replace batteries ofSoil
Moisture Sensor / insert
correctly / use alkaline
batteries.
v Contact GARDENA Service.
v Replace batteries ofSoil -
Moisture Sensor / insert
correctly / use alkaline
battery.
Moisture Sensor.
v Replace cable of Soil
Moisture Sensor.
v Check sensor cable and
connections.
Art. 1186
Obtainable via
GARDENA Service