Ice Quality; Plumbing Problems - Jennair JUIFN15HX Guide D'utilisation Et D'entretien

TROUBLESHOOTING
ICE PRODUCTION (CONT.)
Ice Maker Runs But Produces Very Little Ice
If the accelerated ice production feature is turned
on, this feature will increase the ice production
rate to provide you with more ice in the same
amount of time.
Room temperatures of more than 90°F (32°C) will
normally reduce ice production.
Dirt or lint may be blocking the airflow through
the condenser.
If there is white scale buildup in the ice maker's
water or freezing system, you should clean the
ice maker.
If the drain cap is loose, water will empty from
the water pan and you will have either thin ice or
no ice. Tighten the drain cap.
Ensure that the cutter grid is securely in place
and that its harness plug is connected.
Check that the water filter is properly installed.

ICE QUALITY

Off-Taste, Odor, Or Gray Color In The Ice
If there is unusually high mineral content in the
water supply, the water may need to be treated.
If there is mineral scale buildup, you should clean
the ice maker.
Do not store any food in the ice bin.
Make sure that all packaging materials were
removed at the time of installation.
Thin, Soft, Or Clumps Of Ice
If there is an unusually high mineral content
in the water supply, the water may need to be
treated.
If there is mineral scale buildup, you should clean
the ice maker.
If there is ice in the bin but it is not used
regularly, it will melt and form clumps. Break up
the clumps with the ice scoop provided.

PLUMBING PROBLEMS

Water Not Entering Drain Properly
WARNING
Excessive Weight Hazard
Use two or more people to move and install
ice maker.
Failure to do so can result in back or other
injury.
If the drain hose is not aligned over the drain,
move the ice maker to align with the drain.
NOTE: Service technicians cannot repair
plumbing problems outside of the ice maker.
Call a licensed, qualified plumber if needed.
TROUBLESHOOTING | 13