Vacation Or Extended Time Without Use; Unpack The Ice Maker; Optional Personalizations - Jennair JUIFX15HX Guide D'installation

GETTING STARTED
VACATION OR EXTENDED
TIME WITHOUT USE
When you will not be using the ice maker for an
extended period of time, turn off the water and power
supply to the ice maker.
Check that the water supply lines are insulated
against freezing conditions. Ice formations in the
supply lines can increase water pressure and cause
damage to your ice maker or home. Damage from
freezing is not covered by the warranty.

UNPACK THE ICE MAKER

WARNING
Excessive Weight Hazard
Use two or more people to move and install
ice maker.
Failure to do so can result in back or other
injury.
Removing Packaging Materials
Remove tape and glue from your ice maker
before using.
To remove any remaining tape or glue from
the exterior of the ice maker, rub the area
briskly with your thumb. Tape or glue residue
can also be easily removed by rubbing a
small amount of liquid dish soap over the
adhesive with your fingers. Wipe with warm
water and dry.
Do not use sharp instruments, rubbing
alcohol, flammable fluids, or abrasive
cleaners to remove tape or glue. Do not
use chlorine bleach on the stainless steel
surfaces of the ice maker. These products
can damage the surface of your ice maker.
Cleaning Before Use
After you remove all of the packaging materials, clean
the inside of your ice maker before using it. See the
cleaning instructions in the "Ice Maker Care" section.

OPTIONAL PERSONALIZATIONS

Reversing the Door
For how to reverse the door, refer the "Door Reversal"
section.
Custom Panel Installation
For instructions on how to install a custom door
panel, go to the "Custom Wood Door Panel" section.
If you plan to install a custom overlay panel, you will
need to make the panel yourself or consult a qualified
cabinetmaker or carpenter.
IMPORTANT:
The thickness of the overlay panel must be
3/4" (1.91 cm).
Overlay panel must not weigh more than
8 lbs (3.62 kg).
Overlay panels weighing more than
recommended may cause damage to your
ice maker.
Match wood grain direction with that of
adjacent cabinets.
Sand panel edges to provide a smooth
finish.
Use moisture sealer on both sides and all
edges of the panel to avoid damage from
moisture.
PARTS NEEDED:
Instructions, #8 x 1/2" pan head wood
screws (8)
Stainless Steel Panel Installation
Refer instructions received with Stainless Steel Panel
kit for panel installation.
GETTING STARTED | 5