Cleaning The Ice Maker System; Cleaning The Exterior - Jennair JUIFN15HX Guide D'utilisation Et D'entretien

CARE AND CLEANING
CLEANING THE
ICE MAKER SYSTEM
Minerals that are removed from water during the
freezing cycle will eventually form a hard, scaly
deposit in the water system. Cleaning the system
regularly helps remove the mineral scale buildup.
How often you need to clean the system depends
upon how hard your water is. If you have hard water
of 15-20 grains/gal. (4-5 grains/L), you may need to
clean the system as often as every 9 months.
NOTE: Use one 16 oz (473 mL) bottle of approved
ice maker cleaner. To order, see "To Order
Accessories" on page 14.
1.
Press ON/OFF.
2.
Wait 5 to 10 minutes for the ice to fall into the
storage bin. Remove all ice from the storage bin.
3.
Unscrew the drain cap from the bottom of the
water pan located inside the storage bin. Allow
the water to drain completely.
4.
Replace the drain cap securely on the water pan.
If the drain cap is loose, water and the solution
will empty from the water pan.
5.
Read and follow all handling information on
the cleaner bottle before completing the steps
below.
6.
Pour one bottle of solution into the water pan.
Fill the bottle twice with tap water and pour that
water into the water pan.
7.
Press CLEAN. The light will blink, indicating
that the cleaning cycle is in process. When the
"Cleaning Complete" indicator is illuminated
(approximately 70 minutes), the cleaning cycle is
complete. The system will both clean and rinse
itself during the cleaning cycle.
8.
Remove the drain cap from the water pan after
the cleaning cycle is complete. Look for any
cleaning solution left in the water pan. If cleaning
solution drains from the water pan, you should
run the clean cycle again. Repeat steps 5-7 if
needed. Recheck the water pan for any cleaning
solution. If there is none, securely replace the
drain cap on the water pan. If the drain cap is
loose, water will empty from the water pan and
you will have either thin ice or no ice.
NOTE: Severe scale buildup may require
repeated cleaning with a fresh quantity of
cleaning solution.
9.
Press ON/OFF to resume ice production.

CLEANING THE EXTERIOR

Wash the exterior surfaces and gaskets with warm
water and mild soap or detergent. Wipe and dry.
Regular use of a good household appliance cleaner
and wax will help maintain the finish. Do not use
abrasive cleaners on surfaces as they may scratch the
finish.
For products with a stainless steel exterior, use a
clean sponge or soft cloth and a mild detergent
mixed with warm water. Do not use abrasive or harsh
cleaners. Do not use chlorine bleach on the stainless
steel surfaces.
CARE AND CLEANING | 11